To fix a garbage disposal, first turn off the power at the wall switch or electrical panel. If it is jammed, use an Allen wrench in the bottom hole to manually rotate the blades. If it is totally unresponsive, push the reset button underneath the unit. 1. Clear a Jammed Disposal If your disposal makes […]
How to Repair Garbidge Disposal Read More »
A cracked floor tile is not just ugly. It can collect dirt, let moisture through, and crack the tiles around it. Here is how to replace it yourself. What You Will Need A replacement tile (same size and style) Grout that matches existing grout Chisel or flathead screwdriver Hammer Tile adhesive (thin-set mortar) Notched trowel
How to Replace a Cracked Floor Tile Without a Pro Read More »
A hole in the wall happens to everyone. Whether it is from a doorknob, moving furniture, or an accident, you can fix it yourself in under an hour for less than $10. What You Will Need Self-adhesive mesh patch (for holes up to 6 inches) Joint compound (also called spackle) Putty knife (4-inch) Sandpaper (120-grit)
How to Patch a Hole in Drywall (No Experience Needed) Read More »
A slow or clogged drain is frustrating, but you do not need harsh chemicals to fix it. Chemical drain cleaners can corrode your pipes over time and cost $10-15 per bottle. Try these cheaper, safer methods first. Method 1: Boiling Water The simplest fix. Boil a kettle of water and slowly pour it down the
How to Unclog a Drain Without Harsh Chemicals Read More »
It is the middle of winter and your furnace just stopped working. Before you panic and call for emergency service, try these 5 quick checks. You might save yourself $150 or more. 1. Check the Thermostat Make sure the thermostat is set to HEAT and the temperature is set higher than the current room temperature.
Furnace Not Working? 5 Things to Check Before Calling a Pro Read More »
A dead or flickering light switch is annoying, but the fix is usually simple. Before you call an electrician, try replacing it yourself. What You Will Need A new light switch (matches your old one) A flathead screwdriver A Phillips screwdriver Voltage tester Step 1: Turn Off the Power Go to your breaker panel and
How to Replace a Light Switch in 5 Easy Steps Read More »
Before you call an electrician, check these 3 things:
Dead Outlet? Here’s How to Troubleshoot It Read More »
90% of AC problems are caused by a dirty filter. Before calling an HVAC tech, try this:
AC Not Blowing Cold? Try This First Read More »
